I'm thinking about making a guide/miter gauge setup so that I can keep cuts square when I need to. I've been thinking about ways to do this easily at minimal cost and materials thats still accurate as well as how to mount it to the machine.
December 13, 2009
Scroll Saw
I've gotten tired of always having to use a hand hacksaw to cut material and I thought about getting a little scroll saw to cut small stuff. This little machine was on sale and I thought it would make a good little christmas present for only $70. It can cut up to 2 inch thick material, variable speed, and the table tilts up to 45° for angled cuts.
I'm thinking about making a guide/miter gauge setup so that I can keep cuts square when I need to. I've been thinking about ways to do this easily at minimal cost and materials thats still accurate as well as how to mount it to the machine.
I'm thinking about making a guide/miter gauge setup so that I can keep cuts square when I need to. I've been thinking about ways to do this easily at minimal cost and materials thats still accurate as well as how to mount it to the machine.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment